Operating System
The
POS terminal main board is compatible
with Windows 95/98/2000/XP and Red Hat Linux 9.0. If the drivers are
required, find the necessary files in the “POS & Auto/ID Peripherals” CD
through CD-ROM/Driver/POS.
4.1 Install POS
System by USB CD-ROM
a. Connected an external CD-ROM
to POS-7000 as the figure shown below and insert the installation CD for the
Operating System.
b. Press
the <Delete> key after powering on the system. The system will enter the
BIOS Setup Utility.
c. Select
“Boot” with the
key.
Select “Boot Device Priority” with the
key
and press the <Enter> key.
d. Select
“1st Boot Device” and press the
key.
Press the
key
to select “USB: External CD-ROM.” Press the <F10> key to save and exit the
setting.
e. After
the POS system reboots, it will start to install the operating system from the
CD.
4.2 Adjust CPU Fan Mode and
Brightness
a. Press
the <Delete> key after powering on the
POS system to enter the BIOS Setup
Utility.
b. Select
“Advanced.” Select “Harware Health Configuration” and press the <Enter> key
to go to the sub screen.
c. Select
“CPU Fan Mode” and press the <Enter> key. There are 3 modes for options:
Full On mode makes the
CPU fan run at its full speed.
Automatic mode
makes the system adjust the CPU fan automatically.
PWN Manually mode
enables the users to adjust the CPU fan by entering a number between 0~127.
The higher the value, the higher the speed will be.
d. Select
“PWM Duty control.” Adjust the brightness by entering a number ranges
from Min 20 to Max 127.
The higher the value, the brighter the screen will be.
e. After
configuring the setting, press the <F10> key to save and exit the setting.
The system will reboot automatically.
back |
next
Other POS Terminals
