-19-
-18-
9.2. Visual indicators
· Bluetooth radio link status (scanner)
Red LED off
Red LED flash
Red LED on
Indications: Indicates the scanner is at Bluetooth radio
link off state.
Operation:
To enable Bluetooth radio link on state,
by pushing and holding the trigger over 5
seconds.
Indications: Indicates the scanner is at Bluetooth radio
link on state and the scanner makes
attempts to connect with receiver.
Operation:
To wait few seconds or shorten the
distance between scanner and receiver or
adjust the direction of scanner which help
scanner attempts to connect with receiver.
Indications: Indicates the scanner is at Bluetooth on
state and the radio link between the
scanner and the receiver is built.
Operation:
To disable the radio link on state by
pushing and holding the trigger over 5
seconds.
· Bluetooth radio link status (receiver)
Red LED flash
Red LED on
Indications: Indicates Bluetooth radio link with scanner
break (it's possibly caused by poor
communication quality or radio link is set
to off state.)
Operation:
To enable Bluetooth radio link on state, by
pushing and holding the trigger over 5
seconds or shorten the distance between
scanner and receiver or adjust the direction
of the scanner.
Indications: Indicates Bluetooth radio link with scanner
set to on.
Operation:
To disable the radio link on state by
pushing and holding the trigger over 5
seconds.
-20-
-21-
·
·
·
Programming to be done successfully (scanner)
Purge scanned data from scanner (scanner)
Recharge (scanner)
Green LED on then Red LED on
Green LED on then Red LED on
Green LED Flash
Indications: Indicates programming to be done
successfully.
Operation:
Refer to user's manual part 7.
Scanner programming.
Indications: Indicates scanner purge scanned data
successfully.
Operation:
Refer to user's manual part 8.
Purge scanned data from scanner.
Indications: Indicates the scanner is at charging state.
Operation:
When DC plug either from external power
adapter or USB retrieving power cable
plug in to DC jack on the scanner, and
push & hold the trigger over 5 seconds, the
scanner enables the charging process.
Green LED On
Green LED on then off
Green LED flash after trigger push and no scanning
light emit from scanner window
Indications: Indicates the scanner (battery) is at full
charged state.
Operation:
It takes about 4 hours to complete the
charging process.
Indications: Indicates the scanner performs a good
barcode read.
Operation:
Operate scanner to read a barcode.
Indications: Indicates scanner is at memory full state.
Operation:
To transmit the storage data to host or
purge the data.
· Scanning barcode label (scanner):
Memory full status (scanner):
·
