-7-
-6-
5.2.2. Using external power adapter (option)
·
·
·
·
·
Turn off the host computer.
Connect the D-type 9-pin cable connector of the
receiver to the proper COM port on the host computer.
Connect the DC plug of the external power adapter to
the D-type 9-pin connector's DC jack of the receiver.
Connect the external power adapter into an AC outlet.
Turn on the host computer.
Application software must include RS-232 utility
to obtain the data from COM port which connects
the receiver.
Note:
AC power
Source
RS-232 port
PS/2 retrieving
power cable /
RS-232 port
5.2. BT-XXXX-R: RS-232 interface
5.2.1. Using PS/2 retrieving power cable (default)
·
·
·
·
·
·
·
Turn off the host computer.
Connect the D-type 9-pin cable connector of the
receiver to the proper COM port on host computer.
Disconnect keyboard cable from keyboard port.
Connect the PS/2 retrieving power cable to the
keyboard port on the host computer.
Connect the keyboard cable into the female 6-Pin DIN
connector of the PS/2 retrieving power cable.
Connect the DC plug from the branched cable of PS/2
retrieving power cable into the D-type 9-Pin
connector's DC jack.
Turn on the host computer.
Application software must include RS-232 utility
to obtain the data from COM port which connects
the receiver.
Note:
To keyboard port
To DC jack
To keyboard cable
-9-
-8-
5.3. BT-XXXX-U: USB interface
·
·
·
Turn off the host computer.
Connect the USB A type connector on the receiver into
the USB port on host computer.
Turn on the host computer.
When configuring the receiver, the USB driver
must be prior installed. The driver can be found
from the bundled CD disk.
Note:
6. Three operational modes:
6.1. Batch mode (default):
6.2. On-line mode:
6.3. Recapture mode:
Scanner transmits scanned barcode data right after
scanning barcode label to receiver or scanner stores
scanned barcode data right after scanning barcode
label when the Bluetooth radio link breaks, or the
communication quality of the radio link is poor.
Whenever the Bluetooth radio link rebuilds, the
stored data will be transmitted to receiver right after
trigger pushed. Scanner doesn't allow any barcode
reading attempts while the stored data is being
transmitted to receiver.
Scanner transmits scanned barcode data right after
scanning barcode label to receiver or scanner doesn't
emit the scanning light from its window after
pushing trigger when the Bluetooth radio link breaks
or the communication quality of the radio link is
poor.
Scanner acts as Batch mode's behaviors except all
the scanned dataum are stored in the memory. The
stored data can be transmitted to receiver by
scanning the special barcode label at the manual or
purge the stored data in the memory by running the
utility. To execute stored data transmission and purge
functions must be under radio link builds.
USB port
